The following buttons are available at the top of all pages in the application.
Dashboard
Configuration Settings
Network Settings
Firmware Update
Logs
DSP
Help
Manual
Logout
Standalone Operation
This device can run in Standalone Operation mode, where it will not interact with a
Nyquist server (e.g., E7000 or C4000). This means the device will not:
• Fetch device configuration from Nyquist server
• Register with Nyquist server (via SIP)
• Store backup information to Nyquist server
• Allow access to Nyquist server-based NTP
Table 2. Appliance Dashboard Buttons
Displays the dashboard.
Accesses the Configuration Settings page where you can
view and set various options. If Standalone Operation is
not enabled, you can also receive configuration settings
from a Nyquist server.
Accesses the Network Settings page where you can view
and set network settings, such as the static IP address.
Accesses the Firmware Update page where you can view
the current Nyquist version, update firmware to a new
version, restore the configuration to factory defaults,
and reboot the appliance.
Accesses log files, which record either events or mes-
sages that occur when software runs and are used when
troubleshooting the appliance.
Accesses the DSP page where you can view and set
parameters for Digital Signal Processing (DSP).
Accesses the appliance's online help.
Displays the appliance's configuration manual.
Logs out of the appliance's dashboard.
3