Table of Contents
Advertisement
Pink Noise
Phase Invert
The DSP features that can be applied to a channel, accessible through the DSP Features
menu, are described in the following table.
Amplifier Mute
Compressor
Delay
Graphic EQ
High/Low Pass
Limiter
Noise Gate
Parametric EQ
Peak Limiter
Presets
RMS Limiter
Router
Table 8. DSP Page
When set to ON, a pink noise signal will be sent to the out-
put channel.
When set to ON, the signal for this channel is inverted,
usually to prevent two similar but out-of-phase signals
from canceling each other out.
Table 9, DSP Features
Eliminates low-level analog noise, such as the "pops" that
can occur when the device is turned on or off.
Lessens the dynamic range between the loudest and qui-
etest parts of an audio signal.
Delays the signal by a specified number of milliseconds.
Uses fixed frequencies to tailor the frequency content of
an audio signal.
Filters out frequencies in the input signal that are above
and below specified high and low cutoff frequencies.
Prevents a signal from exceeding an adjustable maximum
level.
Eliminates low-level hiss, noise, or leakage, particularly
when there is a high level of ambient noise.
Uses a center/primary frequency to allow tailoring of the
frequency content of an audio signal.
Limits the signal to a specified threshold based on the sig-
nal's instantaneous levels.
Provides predefined configurations of DSP features, tai-
lored for specific speakers models.
Limits the signal to a specified threshold based on the sig-
nal's average levels over time.
Routes the audio signals from each input channel to zero
or more output channels, as well as adjusting the level of
each input signal per selected output channel.
21
Advertisement
Table of Contents
