Table 18. Rms Limiter Settings - Bogen NQ-A4060-G2 Configuration Manual

Note: If you want to return to the factory settings, select the
the right corner.
4 Make desired adjustments using the controls described in Table 18, "RMS Limiter Set-
tings," on page 44.
5 Select Enable to apply the settings to the selected channel.
Enable
Threshold
Attack
Hold
Decay
Input meter
Output meter
Limiting LED

Table 18. RMS Limiter Settings

Enables or disables the RMS Limiter DSP effect for this
channel.
Sets the threshold level, which is the RMS level above
which the signal will activate the compressor circuit.
The range is -135 to +21 dB.
Sets how quickly or slowly compression will be applied
to the signal once the audio signal goes above the
threshold level. It specifies the length of time over which
the compression ratio will gradually increase from no
compression to full compression.
The range is 1 to 500 ms.
Sets how long compression will be applied after the sig-
nal has fallen below the threshold.
The range is 1 to 500 ms.
Sets how quickly or slowly compression will removed
from the signal after the signal has dropped below the
threshold and the Hold interval has expired. It specifies
the length of time over which the compression ratio will
gradually decrease from full compression to no com-
pression.
The range is 0 to 2000 ms.
Shows the strength of the input signal.
Shows the strength of the output signal, providing a
visual indicator of the effect of the compressor on the
output signal.
Illuminates when compression is being applied to the
signal.
Reset icon that appears in
44