Bogen NQ-A4060-G2 Configuration Manual page 58

Switch Position
Thermal Protect
Channel 1/2/3/4
Output Limit
Temperature
Standby
Mute
Table 21. Status
Indicates the position of the Amplifier Mode switch
located on the rear of the appliance. Bridged mode is typi-
cally used when higher-power, single-channel operation
with a high-impedance loudspeaker load is needed. For
information about setting the Amplifier Mode, refer to the
installation manual for the appliance.
Appears red if the output channel is being overloaded or
there is an external short and the amplifier has placed
itself into protection mode to prevent permanent damage.
Otherwise, the LED is green.
Appears red if the output signal is too high and is being
clipped or distorted. Otherwise, the LED is green.
Provides the real-time temperature of the appliance in
both Celsius and Fahrenheit. The amplifier enters protec-
tion mode if the temperature exceeds 85 °C.
Indicates if channels A/B and C/D are in Standby mode
(On) or not (Off).
Indicates if channels A/B and C/D are in Mute mode (On)
or not (Off).
54