Muting a Channel
You can mute a channel to cut off an audio signal and stop the input signal from being
sent to the output channel. Note the input signal will still be visible on the IN meter, but
the OUT meter will show that nothing is being forwarded to the output channel.
To mute a channel:
1
On the appliance Web UI's main page, select DSP.
2
Click the
Mute
button for the channel that you want to silence.
The
Mute
button will illuminate red. You can click the
the channel.
Adjusting Volume Levels
The vertical slider control can be used to adjust the channel's output level in 1-dB incre-
ments between -60 and +12 dB. The overall adjusted output level of the channel signal
can be viewed on the
To adjust the channel volume level:
1
On the appliance Web UI's main page, select DSP.
2
Use the channel's slider to adjust the volume level.
Knob Adjustments
Many DSP controls use knobs to adjust one or more settings. The value of a knob can be
adjusted in one of two ways:
1
Click the knob control, hold the mouse button down, and drag the mouse up or down
to increase or decrease the value.
2
Double-click the knob, type a value into the resulting popup, and click the Save but-
ton.
OUT
VU meter, marked in 2-dB increments between -60 and 0 dB.
Mute
button again to unmute
23