Table of Contents
Advertisement
2
Select the Menu button for the channel.
3
From the drop-down menu, select
Note: If you want to return to the factory settings, select the
the right corner.
4
Adjust the following settings as needed.
Threshold
Hold
Standby
The amplifier can automatically be put into a low-power Standby mode if the signal falls
below a specified threshold level for 200 seconds or longer. This can be enabled and the
threshold level set via the Standby settings. When a signal is received that exceeds the
specified threshold, the amplifier will automatically recover from standby mode.
Caution
There may be up to a one second latency for the amplifier to recover from
standby mode, which could cause the beginning of the audio signal to be
lost. For this reason, it may be a good idea to include a second or more of
"comfort noise" at the beginning of the signal to mitigate this effect, or if
necessary, to disable this feature.
Signal
Present.
Table 19. Signal Present Parameters
Sets the minimum level the signal must reach before the
signal LED is illuminated.
Threshold range is -144 to +24 dB.
Sets the minimum number of milliseconds that the signal
LED will remain illuminated.
Hold range is 2 to 200 milliseconds.
Reset
icon that appears in
49
Advertisement
Table of Contents
