Table of Contents
Advertisement
Connecting the System Cables
After installing and fixing the antenna, connect the ACU to
the antenna. Refer to the drawing below for cable connec-
tions.
Single Receiver Connection
•
Connect the RF Cable (15m) from the RF 1 connector on
the antenna to the ANT. RF1 connector on the rear of
ACU.
•
Connect the ACU-Receiver Cable (3m) from the RECEIV-
ER connector on the rear of the ACU to the RF connec-
tor on the receiver.
•
Connect the power cable (10m) from the DC power con-
nector on the rear of the ACU to a suitable 12V / 24V DC
power source.
•
Press the POWER ON switch in front of the ACU to start
the antenna system.
RF 1
RF Cable
Antenna
ACU
DC Power Cable
NMEA
connection
(e.g. GPS)
Figure 16 : Single Receiver Connection
Receiver (Not supplied)
ACU-Receiver Cable
Receiver
PC Cable
21
Advertisement
Table of Contents
