Raymarine STV60 Installation & Operation Instructions page 45

Setting the Use of DiSEqC 1.2
If DiSEqC 1.2 protocol is in use on your receiver, enable the
DiSEqC 1.2 setting on the ACU to process the DiSEqC 1.2
command.
SETUP MODE ?
YES NO
SET SAT PAIR ?
PREV YES NEXT
X6
USE DISEQC 1.2 ?
PREV YES NEXT
1. Press YES to enter setup mode.
2. Press NEXT 6 times to enter the Use
DiSEqC 1.2 menu.
3. Press YES to set the use of DiSEqC
1.2.
USE DISEQC 1.2 : NO
PREV SELECT NEXT
SAVE ?
YES
NO
Options for 'USE DiSEqC 1.2'
YES - Select this option if the DiSEqC 1.2 is used.
NO - Select this option if the DiSEqC 1.2 is not used.
4. Set the USE DiSEqC 1.2 to a desired op-
tion*.
PREV - Shows previous option (YES/NO)
SELECT/ENTER - Set the displayed option
for DiSEqC 1.2.
NEXT - Shows next option (YES/NO)
Press ENTER to move to next screen.
5. Press YES to accept the data.
Press NO to cancel and return to main
setup mode.
45