Table of Contents
Advertisement
Cables
Pre-installation considerations.
• All cables need to be well clamped and protected from physical
damage and exposure to heat and humidity.
• Cables with severe bends are not allowed.
• Where a cable passes through an exposed bulkhead or
deckhead, a watertight grommet or swan neck tube should be
used.
Power Requirements
You need to follow the power requirements to avoid damage to
the system.
Raymarine STV60 has been designed to work on a boat's power
supply rated at 12V / 24 V DC (acceptable range: 9~30 V DC).
If your receiver(s) and television(s) require a 110V/240V AC power
supply, you will need to install a suitable DC to AC converter to
operate the unit(s) from your boat's DC power supply.
RF Cable
This cable is supplied at a length of 15m. If a longer length is required
you should replace this cable with an extended RG6 RF cable (available
separately).
Extending the Cables
The cables that have been supplied with your Raymarine
system should be of adequate length to complete the
installation on most boats. If you do need to extend any of
the cables, refer to Technical Support for advice.
Power Cable
This cable is supplied at a length of 10m.
Note: Exceeding the indicated cable lengths will result in
reduced performance of your system.
15
Advertisement
Table of Contents
