Connecting The System To A Gps - Raymarine STV37 Installation & Operation Instructions

Raymarine Satellite TV Antenna Systems

Connecting the System to a GPS

Your satellite TV system has a built-in GPS. If the internal
GPS doesn't operate properly, you can directly connect your
boat's NMEA 0183 GPS to the system through the ACU's
external GPS connector. To do this you will need a suitable
cable to connect your GPS system and the green 2-way ACU
GPS connector supplied with your Raymarine STV37 / STV45
Satellite TV System.
NMEA OUT (+) GROUND (-)
To Connect the System to a GPS
1. Strip back the insulation of each cable and connect a cable
to each terminal of the 2-way connector.
2. Tighten the locking screws.
Figure 21 : NMEA 0183 GPS Connection
3. Connect the cable from the + (positive) terminal of the ACU
GPS connector to the NMEA OUT wire of the vessel's GPS
system.
4. Connect the cable from the – (negative) terminal of the
ACU GPS connector to the Ground Wire of the vessel's GPS
system.
5. Refit the ACU GPS connector to the rear of the ACU.