Raymarine STV60 Installation & Operation Instructions page 29

TCP/IP Connection
Connection through Rear Panel Ethernet Port
This method requires separate IP configuration on a PC.
1. Connect an Ethernet cable from a PC Ethernet port to the
Ethernet port on the back of the ACU.
2. Go to Control Panel > Network and Sharing Center >
Change Adapter Settings, and right-click on the Local Area
Connection. Then click Properties.
3. Select TCP/IPv4, then click Properties.
4. Change the network settings on a PC;
• IP Address: 192.168. 0.222
• Subnet Mask: 255.255.255.0
• Gateway: 192.168.0.223
5. Use the ACU's IP address to access Aptus
• Default: 192.168.0.223
Figure 26 : ACU to PC TCP/IP Connection
.
®
29