Parts Replacement Procedure; Fixing Unit; Removing The Fixing Unit - Canon LASER CLASS 810 Service Manual

Chapter 9

9.4 Parts Replacement Procedure

9.4.1 Fixing Unit

9.4.1.1 Removing the Fixing Unit

The fixing assembly is in a very high temperature just after operation. Firstly
turn off the power switch and remove the assembly when it is fully cooled.
The height of the fixing unit is adjusted at 2 mounting points at the front (left
door + front cover) prior to shipment. If you need to detach the fixing unit,
apply 2 markings [1] before detaching the unit to enable you to return the unit
to its previous position. When replacing the fixing unit with a new one, carry
out height adjustment.
[1]
1) Remove the rear cover and front cover.
2) Remove the left middle cover, left front cover, and left rear cover.
3) Remove the front left cover.
9-6
[1]
F-9-4
0017-3153
4) Slide the guide (front) [1] to remove it.
- Boss [2] 1pc.
5) Remove the two connectors [1].
6) Remove the fan duct [1].
- Screw [2] 1pc.
7) Slide the fan unit [3] upward to remove it.
- Connector [4] 3pcs.
[1]
F-9-5
[1]
[2]
F-9-6
[1]
F-9-7