Systems Affected; Documents Required; Tools And Measurement Devices Required; Parts Required - Siemens MAMMOMAT 300 Repair Instructions

Prerequisites

Systems affected

MAMMOMAT 300/ 300 CE
MAMMOMAT 3000/ 3000 CE

Documents required

•
MAMMOMAT 300/ 3000 Wiring diagram
•
MAMMOMAT 300/ 3000 Installation and Start-Up Instructions

Tools and measurement devices required

•
Standard service kit
•
Screw clamp
•
Protective conductor meter (item no.: 44 15 899 RVO90)
•
Oscilloscope
•
Digital multimeter (incl. mAs meter)
•
Plexiglas plates for testing Iontomat
•
12 V battery

Parts required

•
Cable harness, item no.:61 64 037 X041E for MAM. 300 through ser.no. 1999
•
Cable harness, item no.:63 41 650 X041E for MAM. 300 CE starting at ser no. 4000
•
Cable harness, item no.:62 40 175 X041E for MAM. 3000 through ser.no. 02999
•
Cable harness, item no.:64 51 350 X041E for MAM. 3000 CE starting at ser.no. 03000

Time required

1 service engineers / approx. 16 hours or
2 service engineers / approx. 12 hours each
NOTICE

Differences between MAMMOMAT 300 / MAMMOMAT 3000

This document describes the replacement of the cable harness for MAMMOMAT 3000
(CE).
Instructions are included concerning service work on MAMMOMAT 300 that differs signifi-
cantly from work done on Mammomat 3000.
Work performed on the Mammomat 300 may still deviate slightly from these instructions.
Siemens AG
Medical Engineering
If the MAMMOMAT 300/3000 has not been updated with the outlet
for the corrugated tubing, perform the update in accordance with
UI 41/95.
Register 5 RXB7-230.091.05
Rev. 03
Page 1 of 2
07. 98 TD SD 24
1 - 1
1
1
1
1
1
1
1
MAMMOMAT 300 / 3000