Table of Contents
Advertisement
Figure 92
5.
Remove the counter-rotating belt; refer to
Replacing the Counter-Rotating Belt (page
6.
Use a ratchet in the square hole in the idler arm
to remove tension on the idler spring
7.
Remove the belt from the mower-deck pulleys
and the clutch pulley.
8.
Install the new belt around the mower pulleys
and the clutch pulley under the engine
93).
Figure 93
1. Clutch pulley
2. Mower belt
3. Spring-loaded idler pulley
4. Ensure that the belt-guide
tab hits against the pivot
hub.
g027729
60).
(Figure
93).
(Figure
g024146
5. Belt guide
6. Spring-loaded idler pulley
7. Square hole in the idler
arm for the ratchet
8. Spring
9.
Rotate and ensure the belt-guide tab hits against
the pivot hub
10.
Using the ratchet in the square hole, install the
belt around the spring-loaded idler pulley
93). Seat the spring ends in the anchor grooves.
11.
Install the belt covers
Replacing the Hydraulic
Pump-Drive Belt
1.
Park the machine on a level surface, disengage
the blade-control switch (PTO), and engage the
parking brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Remove the mower belt; refer to
Mower Belt for Side-Discharge Mower Decks
(page 59)
or
Replacing the Mower Belt for
Rear-Discharge Mower Decks (page
4.
Raise the machine and support it with jack
stands
(Figure
61
(Figure
94).
(Figure
94).
Figure 94
Replacing the
95).
(Figure
g027730
60).
Advertisement
Table of Contents
