Connection Diagrams - Siemens 6SN1123-1AA00-0DA2 Configuration Manual

Connection Diagrams

Note
The following connection diagrams only show the terminal connections.
Further, external components are not completely shown. Refer to Chapter 8.
The following comments should be observed in the connection diagrams:
1. The jumper may only be removed in conjunction with the start inhibit.
2. Not available for unregulated infeed.
3. Connect with terminal 19 of the NE module.
4. Drive bus – round cable
5. Drive bus – ribbon cable
6. Drive bus – terminating connector
7. For an external pulsed resistor, remove jumper 1R/2R.
© Siemens AG 2012 All Rights Reserved
SIMODRIVE 611 Configuration Manual (PJU) – 02/2012 Edition
10
10
10-379