Siemens 6SN1123-1AA00-0DA2 Configuration Manual page 179

6 Infeed Modules
6.5 HFD reactor
Damping resistor
6-178
Together with the HFD reactor, an external resistor must be used for damping
purposes (refer to Fig. 6-14).
Table 6-15 Technical specifications
Order No. 6SN1113–1AA00–
0DAV
Rated power (kW)
Special low–inductance
resistor
including the connecting
cable [m]
Connection
Weight [kg]
Degree of protection
acc. to DIN EN 60529
(IEC 60529)
UL file
Ambient temperature
[°C]
Dimensions (W x H x D)
[mm]
1) The 300 W resistance can be used for HFD applications if
the following is true after a warm–up run when all axes are shut down in a regulated way:
S
After an operating period of over two hours, no temperature in excess of 150 _C
may occur on the surface of the 6SN1113–1AA00–0DA0 resistor.
S
This warm–up run must be repeated if the hardware configuration, e.g. motor cable
lengths, is changed!
2) Preferred type
3) Alternative possible
Note
Preferably, the HFD damping resistor (6SL3100–1BE21–3AA0) should be
used. It must not be connected as an external pulsed resistor on the pulsed
resistor module or UI module!
The HFD damping resistor can become very hot. Consequently, it must be
installed so that it cannot be touched or placed at an endangered position with
an appropriate warning notice.
Danger
During operation and briefly after being switched off, the surfaces can reach
temperatures that can cause burns and results in fires
Reader's note
For mounting information and instructions for external HFD resistors, refer to
Fig. 6-14 and Chapter 6.7.4.
SIMODRIVE 611 Configuration Manual (PJU) – 02/2012 Edition
Pulsed resistor HFD damping
1)
0.3/25 kW resistor
6SL3100–1BE21–
3AAV
0.3 0.8
0...230 kHz p3 dB
3 5
2
3 x 1.5 mm 4 x 1.5 mm
1.45 5.5
IP 54 IP51
E–228809 E–212934
0...55
80 x 210 x 53 277 x 552 x 75
© Siemens AG 2012 All Rights Reserved
05.08 02.12
05.01
Pulsed resistor
2) 3)
Plus 1.5/25 kW
6SL3100–1BE22–
5AAV
1.5
5
2 2
4 x 2.5 mm
5.6
IP20
E–192450
193 x 410 x 240