Multirotor Basic Menu; Model Type; Aux Channel Setting - RadioLink AT9S PRO Manual

6.1 MULTIROTOR BASIC MENU

The basic function menu is same like ACRO, GLID and HELI, please find the detail in the former chapters.
Below is the special option:

6.1.1 MODEL TYPE

Different from ACRO, GLID AND HELI, MODEL TYPE for
MULTIROTOR has an additional function TRIM, which is
controlled by the VR switch. Set the TRIM OFF to avoid a
mis-operation damage to the model.
Goals
Select proper MODEL
TYPE. (Ex:
MULTIROTOR）

6.1.2 AUX Channel setting

AUX channel for MULTIROTOR is channel 6 to 10, same like ACRO, GLID and HELI, to set auxiliary channel.
CH5 is special for ATTITUDE, enter CH5 and press PUSH for ATTITUDE. Select 3-section and 2-section
switch to get 6 different attitudes. By DIAL set 6 different rates according to the attitudes.
6.2 ADVANCE MENU FOR MULTIROTOR
Set the rate in each
attitude. Ex: ATTI is 50%.
Change CH6, use VR (D)
to control change other
channels as needed.
Close
Steps
Open BASIC menu, find
MODEL TYPE.
Go to MODEL TYPE
Choose proper model
type (Ex: MULTIROTOR).
Confirm the change.
Turn on the trim.
Close
to ATTI ，
to CH6
，
Repeat as needed.
Inputs
Turn on the transmitter,
menu (If ADVANCE,
to MODEL TYPE
to TYPE
to MULTIROTOR,
Displays, to confirm.
to AILE-TR
，
Repeat above to turn on other trims
77
Radiolink Electronic Ltd
www.radiolink.com
to 50%
to VR(D).
for 1 sec. to BASIC
again)
for 1 sec. 'Are you sure?'
to ON.