Model Type; Binding; Two Signal Working Modes Of R9Ds - RadioLink AT9S PRO Manual

BUTTON. Turn the DIAL while still holding the END BUTTON: clockwise to brighten and
counterclockwise to darken the display.
5. User name setting: user name can be set by DIAL and PUSH with letters and numbers.
6. Alarming voltage:
Transmitter: preset 8.6V, can be self-set
Receiver: preset 4.0V, can be self-set
Ext: preset 10.1V, can be self-set

1.3.2 Model type

Under basic menu, use DIAL to select MODEL TYPE and enter by pressing PUSH. There are 6 different type
included in the system, HELICOPTER, AEROBASIC, GLID(1A+1F), GLID(2A+1F), GLID(2A+2F), and
MULTIROTOR, after model type is selected, press and hold PUSH for 1 second, when the word "are you sure
to change" displayed, model type is changed.

1.3.3 Binding

Each transmitter has an individually assigned, unique ID code. Receiver should bind to transmitter before
starting operation. Once binding is complete, the ID code will be stored in the receiver and no further binding
is necessary unless the receiver is used with another transmitter. When you purchase a new R9DS, this
procedure is necessary; otherwise the receiver will not work.
1. Put the transmitter and the receiver close to each other about 50 centimeters.
2. Power on AT9S Pro and receiver R9DS. The RED LED will be on.
3. Turn on AT9S Pro and it will automatically bind with the closest receiver.
4. There is a black binding button (ID SET) on the side of receiver. Press the button for more than 1 second
and release, the RED (by default, could be Purple for SBUS&PWM signal output) LED will flash, meaning
binding process is ongoing.
5. When the LED stops flashing and is always on , binding is complete.
6. Make sure servos connected with the receiver can be operated by the transmitter.

1.3.4 Two signal working modes of R9DS:

There are two signal working modes, PWM and SBUS&PWM signal output. Short press ID SET twice within
1s, the working mode will change. The RED led indicates the PWM output and BLUE/PURPLE led indicates
SBUS signal.
(1) PWM signal output working mode：RED led indicates PWM signal output, 9 channels totally
Antenna
LED
Indicator
Telemetry Connection
Port
ID
SET
9
Radiolink Electronic Ltd
www.radiolink.com
CH1 (AILE)
CH2 (ELEV)
CH3 (THRO)
CH4 (RUDD)
CH5 (AUX)
CH6 (AUX)
CH7 (AUX)
CH8 (AUX)