Throttle Cut - RadioLink AT9S PRO Manual

2.3.8 Throttle Cut

AEROBASIC
Throttle cut (THR-CUT) (ACRO0/HELI): provides an easy way to stop the
engine by flipping a switch (with THROTTLE STICK at idle). The movement
is largest at idle and disappears at high throttle to avoid accidental dead
sticks. In HELI, there is an additional setting.
The switch's location and direction must be chosen. It defaults to NULL to
avoid accidentally assigning it to a switch, which might result in an
unintentional dead stick in flight.
Goals
Decrease the throttle
setting (at idle) to stop
the engine with the flip of
a switch.(NOTE that you
MUST assign a switch.
The default is NULL. We
recommend SWICH C in
the down position, with
IDLE-DOWN
programmed to SWITCH
C in the center and down
position.)
* Also LOGIC SW(Lsw1 to 3) may be assigned.
** Normally, a setting of 10-20% is sufficient. Viewing the carburetor barrel until it fully closes is adequate to
get an approximate setting; then test with engine running to confirm.
GLIDER
Provides an easy way to stop the engine by flipping a switch no matter where the air brake stick is. The
movement of servo will be -30%. Now you must select switch position and direction. Factory setting the
position is NULL to avoid an accident setting on a switch to cause glitches during flight.
Adjustability:
• Range: -30% to +30%. Movement of servo is 0%, air brake stick is on its min and -30% on the max.
• SWA-H and logic switch Ls1-3 is selectable
• All position is available for logic switch including NULL (usually MIX OFF), you can set MIX by different
position of a switch (UP & CEN, CEN & DN) and also NORM, REV.
Repeat above steps for elevator and rudder.
Close
Steps
Open BASIC menu, then Open
THR CUT
Activate the function .Choose
desired switch, and the position
which activates the function.
With Throttle Stick at idle, adjust
the rate.
Until the engine consistently
shuts off but throttle linkage is not
binding.
Close
Inputs
for 1s .(If ADVANCE
to THR CUT. PUSH. 。
to MIX,PUSH,
to SW,PUSH,
to POSI,PUSH
SWC to DOWN position.
Throttle Stick.
to Rate.
23
Radiolink Electronic Ltd
www.radiolink.com
【THR CUT】
MIX：INH
RATE： 0%
THR:5%(100%)
SW：SwH
POST：DOWN
again) .
to ON，PUSH
SWC，PUSH
to DOWN,PUSH
until shuts off.