Installment Of Antenna; Radio Basic Setting; Basic Setting Of Transmitter - RadioLink AT9S PRO Manual

8
spare/mixture control
9
10
channel 1~9 of the receiver R9DS, connect the receiver with the related servo, you can control the servos by
the correspondent switch.
To be clear, the servo connected with the receiver channel 1 is controlled by the radio aileron lever; servo
connected with channel 2 is controlled by elevator lever; servo connected with channel 3 is controlled by
throttle stick; servo connected with channel 4 is controlled by the rudder lever. Channel 5~9 can be self-set
with the related switches by the menu AUX-CH, and the sub menu. For channel 9, the LED indicator on the
receiver flashes blue for S-BUS signal and red for PWM.

1.2.3 Installment of antenna

Installment of antenna
1. Receiver Antenna Installment
① Keep antennas as straight as possible, or the effective control range will reduce.
② Big models may contain metal parts that influence signal emission. In this case, antennas should be
positioned at both sides of the model to ensure the best signal status in all circumstances.
③ Antennas should be kept away from metal conductor and carbon fiber at least half inch away and no
over bending.
④ Keep antennas away from motor, ESC or other possible interference sources.
⑤ Press and hold the ID SET for more than one second and receivers will start to work with the RED
LED on.
Note Receiver contains some electronic components of high-precision. Be careful to avoid strong vibration
and high temperature.
When all the above steps are complete, please turn off the transmitter and repower on to test if the receiver is
correctly connected with it.
2. Transmitter Antenna Installment
① The transmitter antenna is adjustable so please make sure that the antenna never points directly
at the model when flying as this may possibly decrease the receiver signal.
② Keep the antenna perpendicular to the transmitter to optimize the receiver performance. It also
depends on how you hold the transmitter. But in most cases, adjusting the antenna with perpendicular
position to the transmitter surface will achieve the best result. Please adjust the transmitter antenna
according to the way you hold the transmitter.
Never grip the antenna when flying as this degrades= effective control range..
③

1.3 RADIO BASIC SETTING

1.3.1 Basic setting of the transmitter
1. Display language: can be selected the display language of the function name, etc. in each function menu.
The screen reads "LANGUAGE". Change this to the desired language.
2. Stick Mode: The screen reads "STK-MODE". Change this to the correct mode. Note that this will NOT
change the throttle and elevator ratchets, etc. Those are mechanical changes that must be done by a
service center.
3. RF Mode: the LED indicator will become solid green when RF Mode is active.
4. Adjusting Display Contrast: To adjust the display contrast, from the home menu press and hold the END
Spare
spare
The above listed receiver and channels is referred to the
8
Radiolink Electronic Ltd
www.radiolink.com