Chamber-Flp - RadioLink AT9S PRO Manual

Adjustability:
• Delay time (-DLY-) range of 0 to 100%. The delay time is 10 second at 100%.
Goals
Open ADVANCE menu,
then open START DELAY.
Activate the function
Ex: delay time=5
second.
Set the delay time.
(Ex:50% each surface)
Close

4.3.6 CHAMBER-FLP

CAMBER FLAP assigns the primary flap control [defaults to VR (A)] to allow trimming in flight of the flap
action. The up and down travel of each flap (camber flaps: FLP1/2) can be adjusted independently. Also the
center position of flap servo can be offset.
Note: If FLAP-TRIM is activated, you can not use CAMBER
FLAP function simultaneously.
Adjustability
• Rate: -100% to +100%, with a default of +30%
• Center position (CENTER): The operation reference point of flap
can be offset. -100% to +100%, with a default of 0%.
Note: When changing the polarity of a rate, "change rate dir?"
is displayed for a check. Please set up after pressing DIAL for 1
second and canceling an alarm display.
Goals
Ex: Set the maximum
travel of 35% of the
total flap travel.
Steps
Steps
Open the CAMBER FLAP
function.
Adjust the up/down trim
amount separately.(Ex:
adjust to 35%)
Or: adjust the center position
of flap servo
Close
Inputs
to BASIC . again to ADVANCE
to START-DLY,
to MIX to OFF or ON
，
to ELEV ， to 50%
to RUDD to 50%
，
Repeat as needed.
Inputs
to BASIC .
to CAMBER-FLP,
to FLP
VR (A)，
VR (A)，
Repeat.
to CENTER
55
Radiolink Electronic Ltd
www.radiolink.com
again to ADVANCE
。
to 35%，
to 35%，
。
to desired point.
，