RadioLink AT9S PRO Manual page 18

For additional details on each function, see that function's section in this manual.
Example
Install all servos, switched, receivers, etc. per your model's instructions. Turn on
transmitter then receiver; adjust all linkages so surfaces are nearly centered.
Prepare your
Mechanically adjust all linkages as close as possible to proper control throws. Check
airplane
servo direction. Make notes now of what you will need to change during
programming .
Open the Basic menu, then
open the PARAMETER
Name the model
Go to Model Name
(Note that you do
not need to do
anything to 'save'
or store this data).
Input airplane's name
Close the Model submenu
In the BASIC menu find the
Need to adjust EN
END POINT
D-POINT to meet
with the related ser
vo.
Adjust end point (EX: THRO
servo)Close the function
With digital trims you don't shut the engine off with THROTTLE TRIM. Let's set up IDLE-DOWN and 'throttle
cut'
Goals
Idle down setting: Idle
down is to lower the en
gine speed for landing,
snap rolling acrobatic
display, and launching
etc. It is preset OFF an
d mainly used to start
engine and glide, then
to avoid flameout.
THR CUT shuts the
engine off completely
with the flip of a
switch.(Note: Do Not
assign IDLE DOWN
and THR CUT to both
position of a 2 position
switch
Steps
Steps
From the BASIC menu choose IDLE
DOWN.
Activate and adjust IDLE DOWN
Optional: change switch C command
Close the function
From BASIC menu, choose THR CUT
Input for Example
T urn on the transmitter.
for 1second to basic menu.
to Mode， to Mode name， press PUSH to setting
To change first character, when proper character is
displayed, push to select.
character. Repeat as needed.
return to BASIC menu
to END POINT，press
to Throttle Throttle stick until carburetor closes
as desired. until throttle arm just open carburetor
at fully throttle stick. Repeat for each channel as
needed.
to IDLE DOWN，press
to MIX， press
C to center position, screen now reads
ON.
to RATE, to increase rate until engine
idles reliably but low enough to sit still.
to POSI，press
press
BASIC menu，
screen.
to THR CUT，press
13
Radiolink Electronic Ltd
www.radiolink.com
to choose model
To move to next
to set
Input for Example
to ON， press
，
as you desired
，
again to startup