Thr Curve (Acro) - RadioLink AT9S PRO Manual

auxiliary channel such as 8, and then using some creative mixes.
Goals
Activate
THR-DELAY for a
ducted-fan replica
of a
turbine-powered
MULTIROTOR.
Slow the servo
response by one
second.

3.3.14 THR CURVE (ACRO)

This function adjusts the throttle operation curve for optimum the engine
speed to throttle stick movement.
Note: If the throttle EXP function is activated, you can not use
THR-CURVE function simultaneously.
Adjustability:
• Separate curves for each switch position are available.
• Moving and deleting the curve point: The curve point (-STK-) can be
moved to the left or right by turning the DIAL (up to 2% in front of the adjoining point) and deleted/returned by
pressing the DIAL for one second alternately.
Goals
Base point: Adjust base point of
throttle curve until engine idles
reliably.
-Out-:output,servo position.
-STK-: curve point, stick position.
Steps
Open THR-DELAY
Activate the function.
Adjust the RATE to match the
desired servo speed.(Ex:40%)
Close
Steps
Open THR-CURVE
Activate the function.
Adjust the 1
Optional: assign the switch.
Optional: Move the curve
point.(Ex: point 3)
Optional: delete the curve
point. And return the curve
point.(Ex: point 3)
Adjust the next point.
Close
Inputs
to BASIC .
to THR-DELAY,
to MIX.PUSH.
to RATE.PUSH
Inputs
to BASIC .
to THE-CURVE,
to MIX.PUSH
to P1(-out-).PUSH
st point
position
to SW.PUSH，
to P 3 (-stk-),PUSH
curve point to move to left or right.
to P 3 (-stk-).
curve point.
to P 3 (-stk-)，
Repeat as needed.
48
Radiolink Electronic Ltd
www.radiolink.com
again to ADVANCE
to ACT.
to 40%
again to ADVANCE
to ON.
to desired servo
to desired switch.
to desired
for 1sec.to delete the
for 1sec.to return