RadioLink AT9S PRO Manual page 81

TYPE.
(Ex: MULTIROTOR)
Name the model.
Note that you do not need
to do anything to 'save' or
store this data.
For proper control
operation, reverse servos
as needed.
Adjust travels as needed to
match model's recommend
throws(usually listed as high
rates)
Set up dual/triple rates and
exponential (D/P, EXP)
(Note that in the middle of
the left side of the screen is
the name of the channel
and the switch position you
are adjusting. Two or even
THREE rates may be set
per channel by simply
choosing the desired switch
and programming
percentages with the switch
in each of its 2 or 3
positions.
Adjust AUX-CH and Knob.
find the MODEL TYPE.
Go to TYPE
Choose proper model
type (Ex: MULTIROTOR).
Confirm the change.
In BASIC menu, Open
MODEL SEL.
Input MULTIROTOR's
name.
Close
In the BASIC menu, open
REVERSE.
Choose desired servo
and reverse its direction
of travel.(Ex: reverse
rudder servo)
From BASIC menu
choose END POINT.
Adjust the servo's end
points.(Ex: throttle servo)
Close
Back to choose D/R EXP.
Choose the desired
control and set the first
(Ex: high) rate throws and
exponential.
set the first (Ex: low) rate
throws and exponential.
Optional: change dual
rate switch assignment.
On BASIC menu, then
open AUX-CH function.
Choose CH5 to set
ATTITUDE
Assign the switch to
control attitude. Ex: SW3
is SWC，SW2 is SWB
menu (If ADVANCE,
to MODEL TYPE
to TYPE
to MULTIROTOR,
Displays, to confirm.
to MODEL SEL.
character of model name is highlighted)
to change the 1
next character, repeat as needed.
to REVERSE
to CH4： RUDD,
sure?' Displays.
Repeat as needed.
to END POINT,
to CH1:AILE
percentage. VR(A) to repeat above steps.
to D/R,EXP
to CH to CH:2 (ELEV)
，
SwA screen reads ELEV (UP)
to D/R
Elevator Stick
Elevator Stick
the same as down.
to EXP
Elevator Stick
Elevator Stick
to D/R SwA to down，repeat to set low rate.
to SW
，
position. Repeat steps above to set 3
to AUX-CH,
to CH5, to ATTITUDE
to SW3,
，
to SW2,
，
76
Radiolink Electronic Ltd
www.radiolink.com
again)
for 1 sec. 'Are you sure?'
， to NAME (the 1
character. . move to
st
to BASIC.
to choose REV.
，
， so REV highlighted, 'Are you
to BASIC.
VR(A), to desired
，
to set rate.
to set rate. （Normally set
to set rate.
to set rate.
SwG， SwG to center
rd rate.
to SWC，
to SWB，
st