RadioLink AT9S PRO Manual page 57

Set up dual/triple rates and
exponential (D/R, EXP).
(Note that in the middle of the
left side of the screen is the
name of the channel and the
SWITCH position you are
adjusting. Two or even three
rates maybe set per channel
by simply choosing the desired
SWITCH and programming
percentages with the SWITCH
in each of its 2/3 position.)
Move flap control from the (VR
(A)) dial to the left slider.
[VR(D)](AUX-CH) .
4.2 SET GLID TYPE
TYPE: (GLID 1A+1F), GLID (2A+1F), GLID (2A+2F)
Before doing anything else to set up a glider or sailplane, first you must decide which MODEL TYPE best fits
your MULTIROTOR.
• GLID(1A+1F): The GLID (1A+1F) MODEL TYPE is intended for sailplanes with one or two aileron servos (or
none), and a single flap servo (or two connected with a y-connector). This TYPE is meant to be a very
simplistic version to set up a basic glider without a lot of added features. Additional flight condition is available.
• GLID (2A+1F): The GLID (2A+1F) MODEL TYPE is intended for sailplanes with dual aileron servos and a
single flap servo (or two connected with a y-connector). Additional flight conditions are available. These flight
Choose the desired
control, and set the first
(Ex: high) rate throws
and exponential.
Set the second (Ex: low)
rate throws and
exponential.
Optional: change dual
rate SWITCH
assignment. Ex: elevator
to SWITCH G with 3
positions.
In the BASIC menu,
open AUX-CH.
Choose CH5. Change
primary control to VR(D).
Change other channels
as needed.
Close
52
to CH to CH2(ELEV).
，
A to UP position. Screen reads ELEV [UP]
to D/R
Elevator Stick.
，
Elevator Stick. to set.
（Normally the same for both direction）
to EXP
Elevator Stick
Elevator Stick
to D/R A to down position. Repeat
，
above to set low rate.
to SW to G，
，
Repeat steps above to set 3rd rate.
to AUX-CH
to CH5 to VR(D)。
，
Repeat steps above to set other channels.
Radiolink Electronic Ltd
www.radiolink.com
to set .
to set
to set
G to center.