Flaperon (Acro/Glid 1A+1F ) - RadioLink AT9S PRO Manual

Point 1: 25%
Point 2: 8%
Point 3: 0%
Point 4: 10%
Point 5: 28%
ON when SWITCHC is down.
LINK should be ON if model
has twin e l e v a t o r s e r v o s .
O t h e r w i s e , LI NK remains
OFF .
(Note that point 3 is 0%.
Otherwise, the elevator would
be retrimmed when the mix is
active and no rudder input is
given.)

3.3.3 FLAPERON (ACRO/GLID 1A+1F ):

The FLAPERON mixing function uses one servo on each of the two ailerons, and uses them for both aileron
and flap function. For flap effect, the ailerons raise/lower simultaneously. Of course, aileron function (moving
in opposite directions) is also performed.
Note: When changing the polarity of a rate, "change rate dir?" is displayed for a check. Please set up after
pressing DIAL for 1 second and canceling an alarm display. (GLID only)
Once FLAPERON is activated, any time you program CH6 or "flap" (i.e. ELEVATOR mixing), the radio
commands both servos to operate as flaps. The amount of travel available as flaps is independently
adjustable in FLAPERON. A trimming feature is also available (see FLAP-TRIM) to adjust both neutral
positions together for straight-and-level flight or slight increases/decreases of the flap angle. END POINT and
SUB-TRIM both still adjust each servo individually.
Adjustability:
• Each aileron servo up travel can be set separate from its down travel, creating aileron differential. (See
example).
• Each aileron servo's travel when actuated as a flap is separately adjustable.
• AILE-2 can be utilized to use a 5-channel receiver and still have FLAPERON. NOTE: The AILE-2 function
only commands the channel 5 servo to operate with the aileron servo as ailerons, and to obey the primary flap
control (travel adjusted in FLAP-TRIM.) It does not provide full flap mix capability as when using a 6+ channel
receiver and channel 6.
Set LINK as needed( Ex: off)
Assign SWITCH and position.
(Ex: change from F to C ，
Down)
Optional: set switch to
STK-THR to activate mix with
THROTTLE STICK.
Optional: set switch position to
NULL. Make mix active at all
time. Not complete with
STK-THR.
Set desired percent at five
stick points.
Close
ACRO
to SW.PUSH.
to POSI, PUSH.
to POSI，
point .
Push 1sec.to set.
to POSI, PUSH,
to POINT -1
Repeat for points 2-5.
GLID
38
Radiolink Electronic Ltd
www.radiolink.com
to C,PUSH
to DOWN
Throttle Stick to desired
to NULL
to 25% ，