Telemetry - RadioLink AT9S PRO Manual

• Three logic switches can be used. (LSW1, LSW2, and LSW3 )
• SW (1): Any SWICH A-H or THRSTKS, SW (2): Any SWICH A-H
• Switch position (POSI)
• Logic mode: AND or OR (MODE)
2.3.15 SERVO display and cycle submenu:
Displays radio's output to channels 1-12(defualt 10
channels, you can upgrade firmware to 12 channels)
The servo submenu includes two features:
• Real-time bar-graph display to demonstrate exactly
what commands the transmitter is sending to the servos.
(This can be particularly handy in setting up models with
complicated mixing functions, because the results of each
stick, lever, knob, switch input and delay circuit may be
immediately seen.)
• Servo cycle function to help locate servo problems prior to in-flight failures. (Channels 1-8)
Goals
View the result of
reassigning channel 6
from VR(A) knob to
three-position
SWITCH C
Cycle the channel 6
servo.

2.3.16 TELEMETRY

Signal strength and receiver voltage integrated into the radio transmitter.
It is displayed as the following configure, also it is in the sub menu
RECEIVE.
Receiver voltage is shown as RX,
External voltage is shown as EXTY.
Find telemetry information: under BASIC MENU, select RECEIVE,
presses PUSH to enter, you can find the telemetry info, shown as below.
RX is receiver voltage, EXT is external voltage. Also temperature and
engine speed (EXT, TEMPERATURE, RPM, and GPS all need telemetry
sensor).
RSSI is signal strength, NULL is for no signal, and 0 is for max.
Connection of telemetry sensor: sensor of EXT, TEMPERATURE, RPM,
GPS can connect one by one with the receiver port DATA.
Steps
Complete desired programming
function.(Ex: in AUX-CH,move ch.6 to
SWITCH C)
Open SERVO function
Move each control to see the
operation.(Ex: SWITCH C in all positions)
Prepare all servos to be cycled and cycle Plug in servos. Power on.
Close
Inputs
See AUX-CH for details.
C to center position. Note change in
position of ch.6 servo.
30
Radiolink Electronic Ltd
www.radiolink.com
for 1s .(If ADVANCE, press again) .
to SERVO ,PUSH