RadioLink AT9S PRO Manual page 41

MASTER SLAVE
OFST AUX2
• Rate: the percentage of the slave's range it will move upon maximum input from the master channel. Ex:
RUDDERAILERON mix, 50%. Ail range=1''. When rudder is moved full right, ailerons move 1/2''.
MASTER SLAVE
RUDD
• Offset: Offsets the slave's center is relative to the master. Ex: Smoke valve opens wider per throttle servo
position when smoke SWITCH is ON. Smoke servo's neutral is moved down from THROTTLE STICK center
to the bottom.
MASTER SLAVE
THRO
Goals
Set up a FLAP-ELEV
mix:
ON when SWITCH C is
in the down position.
No elevator movement
when flaps move
up(spoilers),5%elevator
movement when flaps
move down. Link should
be ON if mode has twin
elevator servos.
Otherwise, Link remains
OFF.
LINK TRIM
OFF ON
LINK TRIM
AILE OFF OFF
LINK
OFF
AUX2
Steps
Open an unused programmable
mix.(Ex: use PROG.MIX3 since it
is already set up for
FLAP-ELEVATOR)
Activate the function
Choose master and slave
channels.
Optional: set Master as OFST or
VR(A-E)
Set LINK and TRIM as needed.
Assign SWITCH and position.
(Ex: change from E to C，Down)
Optional: set switch to STK-THR to
activate mix with THROTTLE
STICK.
Optional: set switch position to
NULL. Make mix active at all time.
Not complete with STK-THR.
Set rate. (Ex: Lo=0%,Hi=5%)
Set OFF SET, if needed.（Ex：0）
Close
SWITCH POSITION
STK-THR
Stick at 1/2.for 1 sec.
SWITCH POSITION
NULL
ANY
TRIM SWITCH POSITION
OFF
E DOWN
Inputs
to BASIC menu,
to PROG.MIX PUSH
to MIX，PUSH，
Already CH6 .Already CH2
to Master，PUSH，
to LINK,PUSH ,
to SW，PUSH,
to POSI，PUSH
to SW ,PUSH
to POSI，
point .
to POSI, PUSH,
to RATE ,PUSH
0%，
to OFST
36
Radiolink Electronic Ltd
www.radiolink.com
RATE
100%
RATE OFFSET
50% 0
RATE OFFSET
100% 100
%
again to ADVANCE
to ON, PUSH
to desired choice
to DWON
to SwC
to DOWN
to STK-THR
Throttle Stick to desired
Push 1sec.to set.
to NULL
VR(A)，
VR(A)past center .
to 0%
OFFSET
0
leave at
to 5%