Merkur 2200, 23:1 Pump Modules - Graco Therm-O-Flow 20 Instructions - Parts Manual

Merkur 2200, 23:1 Pump Modules

301
327
304
334
302
338
317
307
1
7
1
Torque to 50-60 ft-lbs (68-81 N•m).
2
Torque to 145-155 ft-lbs (196-210 N•m).
3
Coat mounting surface of sensor mounting block with
non-silicone heat sink compound. Do not coat sensor.
4
Prior to tightening band clamp (321), RTD sensor (320)
must be fully contained within the sensor mount (322).
334129S
339
315
314
312
305
311
6 7
8
306
316
2
308
335
336
336
337
ti25311a
5
Coat inside of heater (309a, 309b) only to within 3/4 in. of
vertical ends with non-silicone heat sink compound before
mounting.
6
Cap screws (311) must be loose while tie rods (307) are
being torqued.
7
Torque to 150 ft-lb (203 N•m).
8
Apply anaerobic sealant.
310
329
1
318
319
323
324
325
309a
5
320
322
3
321
4
309b
5
326
333
Parts
77