Graco Therm-O-Flow 20 Instructions - Parts Manual page 101

Language: Language displayed on the screen.
Date Format: Choose the format of the date.
Date: Set the date.
Time: Set the time.
Enter Password: If not "0000", the Setup screens will
be password protected.
Screen Saver: The screen will go black after the set
amount of time.
Silent Mode: Disable ADM sounds.
Advanced 2
Temperature Units: Units of measure for displayed
temperatures.
Mass Units: Units of measure for mass.
Specific Gravity: Required to convert the volume
dispensed to mass dispensed for tracking the total
weight and flow rate. When the specific gravity value is
populated, the total mass dispense since the last total
weight reset is shown on the Home screen and the
mass flow rate is shown on the Diagnostic screen.
NOTE: If the Specific Gravity is set to zero, the Home
screen will display a cycle counter instead of grams or
pounds.
Heat Rate Option: Control option where the user can
select the rate at which heat is applied to all zones
enabled or selected. Three options are available,
Normal (default), Fast, and Slow. The Warm Up system
time would be shortest for the Fast option, then the
Normal, and longest if the Slow option is selected. If the
334129S
material set temperatures are less than 200° F (93° C),
the Slow option may be best for the application.
Advanced 3
Disable USB Downloads/Uploads: Disables use of
the USB for downloading and uploading.
Disable USB Log Errors: When disabled, the system
will not warn the user when logs are full. If the logs are
full, the oldest data will be overwritten.
Download Depth: Last _ Days: The USB download will
provide data as old as the number of days entered. Old
data may be in memory but will not be downloaded if
older than the number of days entered.
Appendix A - ADM
101