Graco Therm-O-Flow 20 Instructions - Parts Manual page 104

Appendix A - ADM
Maintenance - A
The system will notify the user at the set interval that
maintenance is required. The fields in boxes can be
edited by the user. "Due" and "Current" are both the
number of cycles since the last reset. "Interval" is the
set number of cycles between maintenance
notifications. "Lifetime" is the number of cycles in the
lifetime of the system.
NOTE: The lifetime cycle count will only be reset if the
ADM is replaced.
NOTE: Maintenance screens will not be displayed on
Mini-5 systems with software versions 1.04.042 or later.
Schedule
Use this screen to set times that the system will
automatically enable and disable heating. See
Schedule, page 36.
104
Gateway 1 and 2
If the Therm-O-Flow system has a communication
gateway module (CGM) installed, an additional
"Gateway" chapter containing 1 or 2 pages will be
available in the setup screens. These pages enable the
user to set the CGM IP or device address, configure the
field bus protocol selections, and enable the user to
view the mapping information programmed into the
CGM module. The screens shown below illustrate the 2
pages provided if an Ethernet I/P CGM module is
installed. Refer to manual 3A5186 for information on
mapping and the screens available for the other field
bus options.
334129S