Moving Or Transporting The Printer; Moving The Printer Over Short Distances - Xerox 8254E User Manual

6 Maintenance
6.4

Moving or transporting the printer

This section describes how to move or transport the printer.
6.4.1

Moving the printer over short distances

This section describes how to move the printer short distances within a building. It does not address the
transport of the printer for long distances, as from one building to another.
• Always maintain the printer in a horizontal position when moving it.
• Do not slant the printer, prop it against a wall, or turn it upside down. There is a
possibility that ink inside the printer may leak. Moreover, normal operation after
shifting to these positions cannot be guaranteed.
• The wheels supplied with the dedicated stand are intended for movement over short
distances on flat indoor floors, not for transporting equipment long distances or
between buildings.
(1) Preparation before moving
When using a dedicated stand, follow the procedure below to move the printer.
1. Make sure that the printer's power has first been turned OFF by pressing the [Power] key.
3.3.2 Turning the power OFF
2. Dispose of waste fluid.
1.3 Important safety instructions
3. Make sure that the bolts that secure the printer to its dedicated stand are tight.
4. Disconnect the power cable(s) and any communication cable from the rear of the printer.
5. Check that the print head is in the rightmost position.
220 8254E / 8264E User Guide