Xerox 8254E User Manual page 53

7. Slide the roll media holder (Right) toward the left and insert its core into the roll media's cardboard
tube. Make sure the media holder is inserted all the way into the tube so that the inside surface of its
flange is flat against the cardboard tube. Do not tighten the fixing lever.
No.
1
2
3
8. Return to the fixing lever of the roll media holder (Left) and ratchet it counter-clockwise to loosen
the media holder again. With both media holders loose, move the entire assembly to the center.
9. Tighten both fixing levers.
10. Engage the damper drive switching plates and their locking brackets on the end of each roll media
holder to increase tension on the media roll to avoid slack and "No media found" errors.
No.
1
2
3
4
8254E / 8264E User Guide
Roll media holder (Right)
Roll media
Fixing lever
Roll media holder (Left)
Roll media holder (Right)
Roll media
Fixing lever
Name
Name
3 Preparing For A Job
43