Moving The Printer - Xerox B210 User Manual

Moving the Printer

WARNING:
• To lift the printer, always use the hand holds on each side of the printer.
• When moving the printer, do not tilt or turn it upside down as the inside of the printer may
become contaminated with toner, which can cause damage to the printer or adversely affect
print quality.
• To prevent you from dropping the printer or injury, lift the printer firmly by gripping the
recessed areas on both sides of the printer. Never lift the printer by gripping any other areas.
Follow these instructions when moving the printer:
1. Power off the printer, then disconnect the power cord and other cables from the back of the
printer.
WARNING:
To prevent electric shock, never touch the power plug with wet hands. When removing
the power cord, ensure that you pull the plug and not the cord. Pulling the cord can damage it,
which can lead to fire or electric shock.
2. Remove any paper or other media from the output tray. If the output tray extension is open, close
it.
3. Remove any paper from the paper tray. Keep the paper wrapped and away from humidity and
dirt.
4. Lift the printer firmly by gripping the recessed areas on
both sides of the printer, then move it to the required
location.
Note:
• When moving the printer, do not tilt it more
than 10 degrees in any direction. Tilting the
printer more than 10 degrees can cause toner
spillage.
• When moving the printer over a long distance,
remove the drum cartridge and toner cartridge
to prevent toner from spilling.
CAUTION: Failure to repackage the printer properly for shipment can result in damage not
covered by the Xerox Warranty or Service Agreement. The Xerox Warranty or Service Agreement
do not cover damage to the printer caused by improper moving.
After moving the printer:
1. Reinstall any parts that you removed.
2. Reconnect the printer to the cables and power cord.
3. Plug in and power on the printer.
Moving the Printer
7.56 kg
16.67 lb.
Xerox B210 Printer
®
User Guide
123