Setting An Ip Address In The Console - HP 10Base-T Hub 24M Manual

Figure 6-16. The IP Configuration Screen

Setting an IP Address in the Console

To set an IP Address on the hub, using the Hub Console, perform the following
tasks:
From the Main Menu, type 2 and press [Enter]. The Hub Console
1.
Interface displays the Management Access Configuration Menu.
Type 1 and press [Enter]. The Hub Console Interface displays the
2.
IP Configuration Screen.
At the Change IP Configuration prompt, type Y and press [Enter].
3.
The console interface prompts you to select the method by which you
want to assign an IP Address to your hub. The two address assignment
options are (B)ootp/DHCP or (M)anual Config.
Type M and press [Enter] to manually assign an IP Address to the
4.
hub. The console interface prompts you to type an IP Address.
At the [Enter] IP Address prompt, type an available IP Address and
5.
press [Enter]. Continue to supply values for the subnet mask,
default router, and Time to Live values when prompted.
6. At the Change and save to new IP configuration prompt, type Y and press
[Enter] to store all values you have set.
Configuration Reference
Note that you
need both a
Subnet Mask and
a Gateway to
have a valid IP
Address.
6-35