HP 10Base-T Hub 24M Manual page 96

Type the name of the Community Name you want to use and press [Enter].
2.
The Community LIst Screen displays the following prompt and information:
Enter in Read View as (N)one, (R)estricted, (U)ser,
(F)ull:
3. Type the Read-level access you want this Community Name to provide
(either N, R, U, or F) and press [Enter]. The Community List Screen
displays some basic Read-Write mapping information. It also displays the
following prompt:
Enter in Write View as (N)one, (D)iscovery, (R),
(U)ser, (F)ull
4. Type the Write-level access you want this Community Name to provide
(either N, D, R, U, or F) and press [Enter]. The Community List
Screen redisplays the home Screen and displays the new Community
Name in the Community Name List. A sample session is shown below.
Figure 6-18. Adding a Community Name
Configuration Reference
In this example, a
Community Name is
being set that provides
Full read access but
only User write access
to device settings,
restricting control of
security settings.
6-39