Setting The Ip Address For The Cp Inband Management Interface; Setting The Ip Address For The Ge Inband Management Interface; Adding A Route On The Cp; Deleting A Route - HP A7533A - Brocade 4Gb SAN Switch Base Administrator's Manual

routeadd destination netmask
[gateway]
routedel destination netmask
destination
netmask
gateway

Setting the IP address for the CP inband management interface

The portCfg inbandmgmt command stores the IP address of the CP inband management interface and
routes in the configuration database and updates the current configuration to use these new settings. To
add the IP address to the internal interface on the CP, use the 'cp' option for the
portCfg inbandmgmt ipaddrset command.
1. Connect to the switch and log in as admin.
2. Enter the portCfg inbandmgmt command to configure an IP address on the CP.
switch:admin> portcfg inbandmgmt ge0 ipaddrset cp 192.168.255.1 255.255.255.0

Setting the IP address for the GE inband management interface

To set the IP address on the internal interface for the GE port processor, use the 'ge' option for the
portCfg inbandmgmt ipaddrset command. These commands will set the appropriate interface
based on the GE port number entered.
1. Connect to the switch and log in as admin.
2. Enter the portCfg inbandmgmt command to configure an IP address to the internal interface on the
GE port processor.
switch:admin> portcfg inbandmgmt ge0 ipaddrset ge 192.168.255.2 255.255.255.0

Adding a route on the CP

1. Connect to the switch and log in as admin.
2. Enter the portCfg inbandmgmt command to add a route to the Management Station.
switch:admin> portcfg inbandmgmt ge0 routeadd 192.168.3.0 255.255.255.0

Deleting a route

1. Connect to the switch and log in as admin.
2. Enter the portCfg inbandmgmt command to delete a route to the Management Station.
switch:admin> portcfg inbandmgmt ge0 routedel 192.168.3.0 255.255.255.0
Specifying the portCfg inbandmgmt command with the routeadd or routedel options adds and
deletes route entries to the CP and the GE port processor routing tables. IP addresses must be configured
for both devices prior to configuring any routes. When configuring the routes for the CP, the GE port
processor inband device address for that GE port is used instead of the specified gateway. If no gateway
Adds a route to the management station for an existing
CP or GbE port (CP or GbE designation is made
automatically). You must specify the destination IP
address and the subnet mask when adding a
management route. You must create the IP addresses for
the CP and the GbE port interfaces before you can add a
route to the routing table.
Deletes a management route from an internal CP or a
GbE port interface. This operand is optional if the
destination is in the same subnet as one of the IP interface
addresses. If the destination is not part of the same
subnet, you must specify a gateway IP address.
Specifies the destination for the route. This is the IP
address of the management station. This operand is
required when adding or deleting a route.
Specifies the subnet mask. This operand is required when
adding or deleting a route.
Specifies the gateway IP address. This operand is
optional if the destination is in the same subnet as one of
the IP interface addresses. If the destination is not part of
the same subnet, you must specify a gateway IP address.
Fabric OS 6.2 administrator guide 549