Manually Setting An Ip Address From The Hub Console - HP 10Base-T Hub 24M Manual

Setting an IP Address for the Hub

Manually Setting an IP Address from the Hub Console

To configure the hub with an IP address:.
1.
2.
3.
.
Figure 3-1. The IP Configuration Screen.
4.
3-4
Start a hub console session and at the prompt, enter ME to access the
menu system region.
From the Main Menu, enter 2 to display the Management Access
Configuration screen.
From the Management Access Management screen, enter 1 to display
the IP Configuration Screen shown in figure 3-1.
Enter Y at the Change IP configuration? (Y/[N]): prompt.
The console prompts you to select the method by which you want to
assign an IP address to your hub. The two options are (B)ootp/DHCP or
(M)anual Config.
DHCP and Bootp are automatic network address selection protocols. See
"Automatically Acquiring an IP Address Using Bootp/DHCP" later in this
chapter.