HP 10Base-T Hub 24M Manual page 141

Configuration Reference
To Add a Backup Link, perform the following
1.
2.
3.
4.
5.
6.
6-84
Type A and press [Enter]. The Hub Console Interface displays the
following prompt:
Enter in primary port in backup link configuration
(1-24, XCVR):
Type the number of the port for which you want to assign a backup port.
Press [Enter]. The Hub Console Interface displays the following
prompt:
Enter in backup port in backup link configuration (1-
24, XCVR):
Type the number of the port that will act as the backup port when the
primary port fails. Press [Enter]. The Hub Console Interface
displays the following prompt:
Enter in MAC Address of test destination.
Type the MAC address of the remote device you are trying to reach. Press
[Enter]. The Hub Console Interface displays the following prompt:
Enter in test time (1 - 15 sec#)
Type the number of seconds that you want to lapse between test packets
transmitted on the primary link to verify that it continues to operate
correctly. Press [Enter]. The Hub Console Interface displays the
following prompt:
Enter in consecutive failures (1-16):
Type the number of times you allow the port to time out during test packet
transmissions before being disabled. Press [Enter]. The Backup
Links dialog box displays the information shown in the screen on the
previous page.