Running A Ping Test In The Console - HP 10Base-T Hub 24M Manual

Figure 6-43. The Ping/Link Test Screen Running a Ping Test

Running a Ping Test in the Console

To run a Ping Test in the Hub Console Interface, perform the following steps:
From the Main Menu, type 4 and press [Enter]. The Hub Console
1.
Interface displays the Diagnostics Menu.
From the Diagnostics Menu, type 2 and press [Enter]. The Hub
2.
Console Interface displays the Ping Test Screen.
3. Type the IP Address of the hub at the Enter Destination IP Address prompt
and press [Enter]. The Hub Console Interface displays the
following prompt:
Enter number of packets to send.
4. Type a number at that indicates the number of packets the hub should
send to the test device to determine whether a valid connection exists
between the two devices. Press [Enter]. The Hub Console Inter-
face displays the following prompt:
Enter timeout in seconds (1-30)
Configuration Reference
The port was able to
pass 10 tests of
attempting to connect
with a device with an IP
Address of
15.31.200.204.
6-97