CDA HG6001SS Installation, Use And Maintenance Manual page 46

of 75˚C above ambient (typically this is between 90˚C and 100˚C).
When correctly installed ensure that there is a gap of 4 mm minimum
between the sides of the oven and adjacent furniture doors.
How to install your oven
You will need the housing area in fig. 12 to fit your oven correctly.
The oven is designed to fit into a cabinet of 600 mm width. The oven
can be built in or built under the kitchen units, but you must ensure
that it is properly ventilated. In the diagram below the built-in oven
is ventilated by means of a space at the top of the kitchen cabinet.
There are many other methods of ventilating your oven - consult a
qualified engineer for advice.
Lift the oven carefully into position on the shelf, taking care NOT to lift
it by the door handle. If you lower the oven door, you will see 4 screw
holes, 2 on each side of the oven (image B fig. 12). The oven should
then be secured
to the housing by
securing screws
into these holes.
Remember the
housing should not
be free standing
but be secured
to the wall and/or
adjacent fittings.
22
A
5 6 0
B
Fig. 12
C
5 6 0