Subaru 2002 Legacy Owner's Manual page 247

B To insert a disc
3
1. Press one of the "Disc select" buttons (numbered from 1 to 6)
2
for which the disc indicator light is "OFF".
The Disc indicator lights are located directly above the corresponding
"Disc select" buttons.
2. The indicator will begin blinking. The blinking will last for 15 se-
conds.
During this period, insert a desired disc, and the disc will begin to
1
play. (If any disc is not inserted during this period, the "Disc slot"
door will close. Repeat step 1.)
Be sure to hold a disc with the label side (the side where titles are
printed) up.
3. To insert another disc, repeat step 1 and 2 choosing a different
disc select button.
B To insert six discs at a time
1. Press and hold the "Disc select" button number 1 until all disc indi-
cators begin blinking (about 1.5 seconds).
2. The indicators will blink for 15 seconds. During this period, insert
desired six discs.
3. When all discs are loaded, the first disc will begin to play. (If no
disc is inserted within this 15 seconds, the entire disc load sequence
will be canceled.)
B To remove a disc
3
1. Press the desired one of the "Disc select" buttons (numbered
from 1 to 6) for which the disc indicator light is on.
4
2. Press the "Eject button" . The selected disc will be ejected and
the indicator light will begin blinking.
3. To remove another disc, repeat step 1 and 2 choosing a different
"Disc select" button.
(To remove discs when the ignition switch is in the "Lock" position,
press the "Eject" button, and the first disc will be ejected. Press the
"Eject" button again, and the next disc will be ejected and so on. At
this time, the "Disc select" buttons are disabled.)
5-66