Subaru 2002 Legacy Owner's Manual page 217

B Waveband selection
n FM/AM selection
Push the "BAND" button
display indicates which one is currently selected.
n FM/AM/Weather band selection
Push the "BAND" button
(WB) reception. The display indicates which is currently selected.
B Stereo indicator
The stereo indicator "ST" will come on when an FM stereo broadcast
is received.
B Tuning (TUNE)
n Manual tuning (TUNE)
Press the tuning button
cy and press the tuning button marked "B" to decrease it.
Each time the button is pressed, the frequency interval can be
changed between 10 kHz in the AM mode and 0.2 MHz in the FM
mode.
Constant pressure on the button causes a continuous change in the
frequency.
n Manual tuning for weather band
When weather band mode is selected, press the tuning button
marked "Y" to change the WB channel up and press the tuning but-
ton marked "B" to change the WB channel down. Each time the but-
ton is pressed, the WB channel changes to the next channel.
Constant pressure on the button causes a continuous change in the
frequency.
n Automatic tuning (SCAN)
Press the "SCAN" button
this mode, the radio scans through the radio band until a station is
found. The radio will stop at the station for five seconds while display-
ing the frequency, after which scanning will continue until the entire
band has been scanned from the low end to the high end.
5-36
2
to select FM1, FM2 or AM reception. The
2
to select FM1, FM2, AM or Weather band
3
marked "Y" to increase the tuning frequen-
6
to change the radio to the SCAN mode. In
3