Subaru 2002 Legacy Owner's Manual page 227

B FM/AM selection button (FM/AM)
3
Push the "FM/AM" button when the radio is on to select FM1, FM2
or AM reception. Each time this button is pressed, the band will
change in the following order:
FM1 FM2 AM
The display indicates which one is currently selected.
B Stereo indicator
The stereo indicator "ST" will come on when an FM stereo broadcast
is received.
B Manual tuning (TUNING)
∧
1
Press the tuning button marked " " to increase the tuning frequen-
∨
cy and press the tuning button marked " " to decrease it.
Each time the button is pressed, the frequency changes 10 kHz in the
AM mode and 0.2 MHz in the FM mode.
Constant pressure on the button causes a continuous change in the
frequency.
B Automatic tuning (SCAN)
2
Press the "SCAN" button to change the radio to the SCAN mode. In
this mode, the radio scans through the radio band until a station is
found. The radio will stop at the station for five seconds while display-
ing the frequency, after which scanning will continue until the entire
band has been scanned from the low end to the high end.
Press the "SCAN" button again to cancel the SCAN mode and to stop
on any displayed frequency.
When the "SCAN" button is pressed for automatic tuning, stations are
scanned in the direction of low frequencies to high frequencies only.
Automatic tuning may not function properly if the station reception is
weakened by distance from the station or proximity to tall buildings
and hills.
5-46