Subaru 2002 Legacy Owner's Manual page 103

and alarm. In warning mode, the alarm detects lower level vibrations
and triggers 2 warning chirps on the horn and two flashes on the
lights as a deterrent to would be vandals. In alarm mode, higher lev-
els of shock are detected and the system will go into full alarm.
D Ignition switch being turned on while in armed state.
NOTE
With the valet mode selected, the security system does not oper-
ate and the parking lights do not flash when the remote transmit-
ter is used for locking and unlocking.
The security system indicator light in the combination meter
flashes twice per second to show that the valet mode is selected.
For details, refer to "Valet mode" in this section.
B Arming the system
n To arm the system using remote transmitter
Press to
Arm the
system.
1. Close all windows and moonroofs (if so equipped).
2. Remove the key from the ignition switch.
3. Open the doors and get out of the vehicle.
4. Make sure that the engine hood (and the trunk lid) are locked.
5. Close all doors (and the rear gate on the station wagon).
6. Briefly press the "LOCK/ARM" button (for less than two seconds).
All doors (and the rear gate on the station wagon) will lock, the horn
will sound one time, the parking lights will flash one time and the indi-
cator light starts flashing slowly (approximately once every two
2-14
Press to
Disarm the
system.
HB1000EB HB2033BB