133 Errors - Lexmark MS517dn Service Manual

133 errors

133 error messages
Error code Description
133.05 CTLS reading above maximum expected value.
133.06 CTLS reading below minimum expected value.
133.08 Excessive CTLS noise.
Unresponsive imaging unit service check
Action
Step 1
a
Check if the imaging unit is a supported and genuine Lexmark
supply. If not, then replace it.
b
Make sure that the imaging unit is properly installed.
c
Make sure that the latest firmware is installed.
Does the problem remain?
Step 2
Check the imaging unit contacts and spring for proper installation
or damage.
Are the contacts and spring properly installed and damaged?
Step 3
Check if the imaging unit contacts and spring are beyond repair.
Are the contacts and spring beyond repair?
Step 4
Straighten the imaging unit contacts and install the spring properly.
Does the problem remain?
Step 5
Clean the CTLS.
Does the problem remain?
Step 6
•
Check the cable PCN3 for proper connection to the power
supply.
•
Check the CTLS cable for proper connection to the controller
board.
Are they properly connected?
Action
Go to
check" on page
Diagnostics and troubleshooting
142
"Unresponsive imaging unit service
142.
Yes No
Go to step 2. The problem is
solved.
Go to step 3. Go to step 5.
Contact the next Go to step 4.
level of support.
Go to step 5. The problem is
solved.
Go to step 6. The problem is
solved.
Go to step 7. Reseat the cables.
4514-6xx