Acm Assembly Removal - Lexmark MS517dn Service Manual

c
Install the flag into the slot (E).
d
Place the hook behind the pick roller assembly supporting bracket (F), and then snap it into place.
Note: To check if the sensor flag is properly installed, do the following:
1
Lift the pick roller assembly.
2
If the sensor flag goes along with the pick roller assembly when lifted, then the sensor flag is properly
installed.

ACM assembly removal

1
Remove the left cover. See
2
Remove the rear door and cover. See
3
Remove the power supply. See
4
Remove the power supply shield. See
"Left cover removal" on page
"Rear door and cover removal" on page
"Power supply removal" on page
"Power supply shield removal" on page
Parts removal
303
228.
307.
289.
290.
4514-6xx