Troubleshooting Powerpack Hv On The Battery Charger - KTM Freeride E-XC 2021 Owner's Manual

23.3

Troubleshooting Powerpack HV on the battery charger

Faults
Blink code 11 on battery
charger
Blink code 33 on battery
charger
Blink code 34 on battery
charger
Blink code 36 on battery
charger
Blink code 64 on battery
charger
Blink code 65 on battery
charger
Blink code 66 on battery
charger
Blink code 73 on battery
charger
The faults are indicated by LED
the following blink codes are displayed on the battery charger and
refer to the Powerpack HV.
Tip
The first step to take in case of any fault is to switch off
the battery charger, wait for 15 seconds, and then switch it
back on.
If a fault is not eliminated by the measures specified here,
an authorized KTM workshop will be happy to help you.
Info
The pause between the signals of the 1st digit is 0.25 sec-
onds.
The pause between the 1st and 2nd digits is 1 second.
The pause between the signals of the 2nd digit is also
0.25 seconds.
The pause until the blink code repeats is 3 seconds.
F03150-11
Possible cause
Charging fault
Overtemperature of the
Powerpack HV
Undertemperature of the
Powerpack HV
Undertemperature of the
Powerpack HV
Charging cable detected in
activated vehicle
Fault in the charging cable
Powerpack HV charging level
too high for charging mode
Storage
Powerpack HV not enabled
TROUBLESHOOTING 23
1
on the battery charger. All of
Action
–
Check the charging plug and charging
cable for external damage and dirt and
reconnect.
–
Allow the Powerpack HV to cool down.
–
Place the Powerpack HV in a warmer
location and allow it to warm up.
–
Continue charging in a warmer loca-
tion.
–
Place the Powerpack HV in a warmer
location and allow it to warm up.
–
Continue charging in a warmer loca-
tion.
–
Switch off the main switch on the vehi-
cle and restart charging.
–
Check the charging plug and charging
cable for external damage and dirt and
reconnect.
–
Empty the Powerpack HV to below
30%.
–
Contact an authorized KTM workshop.
137