Checking The Headlight Setting; Adjusting The Headlight Range - KTM Freeride E-XC 2021 Owner's Manual

16.9

Checking the headlight setting

16.10

Adjusting the headlight range

–
Insert the screw and first turn counterclockwise until it
engages in the thread with a small jerk. Tighten the screw
lightly.
Finishing work
–
Install the Powerpack HV. (
–
Lock the seat. (
–
Check that the turn signal system is functioning properly.
–
Position the vehicle upright on a horizontal surface in front of
a light wall and make a mark at the height of the center of the
low beam headlight.
–
Make another mark at a distance
Guideline
B
Distance
–
Position the vehicle vertically a distance
wall.
400726-10
Guideline
A
Distance
–
The rider now sits down on the motorcycle with a full set of
protective clothing.
–
Turn the ignition key in the ignition lock to the position
–
Push the main switch into position
–
Switch on the low beam.
–
Check the headlight setting.
The boundary between light and dark must be exactly on the
lower marking for a motorcycle with rider.
» If the boundary between light and dark does not meet
specifications:
–
Adjust the headlight range. (
Preparatory work
–
Check the headlight setting. (
Main work
–
Loosen screw
–
Adjust the headlight range by pivoting the headlight.
Guideline
The boundary between light and dark must be exactly on the
lower mark for a motorcycle with rider (instructions on how
to apply the mark: Checking the headlight setting).
Info
E00975-10
A change in weight on the vehicle may require a correc-
tion of the headlight range.
ELECTRICAL SYSTEM 16
p. 109)
p. 69)
B
under the first marking.
5 cm (2 in)
A
5 m (16 ft)
.
p. 105)
p. 105)
1
.
away from the
.
105