14 BRAKE SYSTEM
90
–
Remove cotter pin
–
5
Remove pin
–
Remove brake linings
–
Press the brake piston back into the basic position and ensure
that brake fluid does not flow out of the brake fluid reservoir,
extracting some if necessary.
–
Clean brake caliper.
–
Check the brake discs. (
F03136-10
–
Position the retainer spring.
–
Position the new brake linings.
Info
Always change the brake linings in pairs.
–
5
Mount pin
Info
To make it easier to mount the pin, push the brake lin-
ings upwards against the retainer spring.
Make sure the brake linings and retainer spring are
seated correctly.
–
Mount cotter pins
–
Operate the rear brake lever several times until the brake lin-
ings are in contact with the brake disc and there is a pressure
point.
–
Correct brake fluid level to marking
Guideline
A
Level
(brake fluid level
below reservoir rim)
Brake fluid DOT 4 / DOT 5.1 (
–
Mount cover
–
Mount and tighten screws
F03134-10
Info
Use water to immediately clean up any brake fluid that
has overflowed or spilled.
Finishing work
–
Install the Powerpack HV. (
–
Lock the seat. (
4
.
.
6
and the retainer spring.
p. 79)
.
4
.
A
.
5 mm (0.2 in)
p. 143)
2
3
with membrane
.
1
.
p. 109)
p. 69)